AlarmNet 7845C Uživatelský manuál stáhnout pdf (Strana 6)

How Contact ID is displayed on the printer

Reading a Contact ID message

1 – The “Event Qualifier” is a single character that can be:

 “E” for an Event

 “R” for a Restore

2 – The “Event Code” is three digits and represents a specific type condition. Refer to the Ademco Contact ID

documentation in the instructions of your alarm control panel for specific codes. Below are a few examples of

the conditions that can be sent:

• Medical – Pendant transmitter, Fail to check in

• Fire – Water flow, Pull station, Heat sensor

• Panic – Duress, Silent, Audible

• Burglary – Interior, Perimeter, 24 Hour

• Supervisory, Trouble, Open/Close, Tamper

• etc.

3 – The “Partition” or “Group” is a two-digit number indicates which partition is reporting the alarm. For non-

partitioned panels, the value is always “00”.

AlarmNet Messages Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Žádné komentáře

AlarmNet 7845C Uživatelský manuál Strana 6